Wireless Flash and K10D

[Joe Davis]

I am trying to get the wireless flash mode to work with my K10D and AF360FGZ. I have gone over and over the manual and it basically says I need to make sure they are on the same channel and the flash is set to Slave 2. But I still cannot get it to work.

Any help would be appreciated.

[rhermans]

Don't know much about the flash story only that you have to have a 1.11 firmware at least.

Ronny

[rei_vilo]

Bonjour,

I know this is an answer about the 540 while the question is about the 360, but it may help.

On the 540, slide the power button to Wireless, then press the M/C/S button as many times as to get the SLAVE indicator.

On the K10D, with the P mode, press Fn, the the down key and select W+lighting symbol then OK twice. Then, ask for the menu, select C list, then last page for Wireless flash mode : 1 operates both flashes and 2 operates only the remote flash (the K10D's flash is only used to send the signal).

On both cases, the 540 waits for the signal from the K10D and lights on.

And voilà! Actually, I spent a couple of hours matching the 540 manual with the K10d manual...

Hope this helps...

Best regards from France,

--- rei_vilo